TANDBERG MPS User Manual page 107

TANDBERG MPS User Manual
To use the front panel asynchronous serial port (J23), 'Com 1' port, you need a RJ-45 to RS-232 converter. The pin
assignments for the COM 1 port are as in the Figure �‑2. �O�1 pi��u�. Note that this port is configured as DCE.
Figure �‑2. �O�1 pi��u�
The rear of the System Controller Board is equipped with the following interfaces:
Figure �‑3. �����em ����r���er ���rd ‑ re�r
 2 X LAN / Ethernet (RJ-45) 10/100 Mbps on the back
 1 x COM port
Note: The Enet2 interface is only in use if you are connecting the MPS to two separate IP networks. No other sockets
on the rear system controller board are in use.
10
D13373.04