Proxim Harmony 8550 Manual page 53

2. Confirm that the Access Point and PC Card have the same SSID.
3. Confirm that the Access Point and PC Card have the same Encryption settings, if
enabled.
4. Confirm that the Access Point's Status LED is green or blinking green. A PC
Card cannot associate with an Access Point while the AP's Status LED is either
amber or red.
Problem 3:
The Status LED is amber.
Solution 3:
The Status LED will turn solid amber under two conditions:
G The unit is initializing
G The unit has successfully initialized but could not find an AP Controller to
partner with
If you do not have an AP Controller on the network, confirm that the AP Controller
Dependence parameter is set to either Independent or Flexible. See Chapters 3 and 5 for
details.
Problem 4:
The Status LED is blinking amber.
Solution 4:
The Status LED will blink amber if the Access Point requires a new firmware image.
You can download a new firmware image to an Access Point using either the Harmony
System's Web browser interface or the Access Point upgrade tool (posted on Proxim's
Web site with new Flash Code versions) . If you have an AP Controller on the network,
refer to the Harmony Access Point Controller Model 7560 User's Guide for information
on upgrading Access Point firmware.
53