Proxim Harmony 8550 Manual page 13

Warning!
It is the responsibility of the installer and users of the Harmony 802.11b Access
Point Model 855x to guarantee that the antenna is operated at least 20
centimeters from any person. This is necessary to insure that the product is
operated in accordance with the RF Guidelines for Human Exposure which
have been adopted by the Federal Communications Commission.
2. Place the Access Point in the desired location. An optional wall mount is available
for the Access Point. Refer to the section entitled "Mounting Option" later in this
chapter for details.
3. If you are using a Model 8551 Access Point, connect the two 7015 antennas
directly to the unit. If you are using another model of external antenna, connect the
antennas to the Access Point's antenna connectors with low-loss antenna cabling.
4. Attach one end of an Ethernet cable to the Access Point and attach the other end to
the 10Base-T port of a network hub, switch, router, or patch panel.
Note:
The Harmony 802.11b Access Point does not support 100Base-TX; it only
supports 10Base-T.
5. If you are not using the Harmony Power System to supply power to the Access
Point or want to connect the Access Point to both the Power System and an AC
power source, attach one end of the AC power adapter, included in the product
package, to the back of the Access Point and the other end to a power outlet.
Note:
Use the Access Point only with the power adapter supplied by Proxim in the
product package. Using another power supply may damage the Access Point. If
you want to use the Access Point in conjunction with the Harmony Power System,
refer to the Harmony Power System Model 7562 User's Guide for instructions.
All three LEDs on the top of the Access Point will light up momentarily when the unit is
powered on. In addition, the green Link LED will turn on to indicate that the Access
Point has a network connection.
13