IP Address
Enter an IP address in the field provided to assign the Access Point a static IP address.
Note that the Use DHCP parameter must be set to "No" before the Access Point will use
the configured static IP settings.
Subnet Mask
Enter a subnet mask in the field provided to assign the Access Point a static subnet mask.
Note that the Use DHCP parameter must be set to "No" before the Access Point will use
the configured static IP settings.
Gateway IP Address
Enter the IP address of a network gateway in the field provided to assign the Access
Point a static default gateway address.
Note that the Use DHCP parameter must be set to "No" before the Access Point will use
the configured static IP settings.
AP Controller Dependence
The AP Controller Dependence parameter determines the Access Point's operating
mode. The options are Independent, Dependent, and Flexible.
Refer to Chapter 3 for a description of each of these options.
By default, AP Controller Dependence is set to Flexible, which means that the Access
Point will look for an AP Controller at boot-up. If an AP Controller is not available, the
Access Point will operate in Independent mode.
37