Mounting Option - Proxim Harmony 8550 Manual

By default, the Harmony 802.11b Access Point will attempt to find an AP Controller to
partner with. During this process, the Access Point's Status LED will be amber.
5. If you have one or more AP Controllers on the network, an AP Controller will
automatically detect and configure the Access Point over the network (this assumes
that you have not disabled the Harmony system's ability to automatically detect
new Access Points). The Access Point's Status LED will turn solid green. Refer
to the Harmony Access Point Controller Model 7560 User's Guide for more
information on how to configure an Access Point.
6. If you do not have an AP Controller on the network, the Access Point will auto-
matically switch to Independent mode (which does not require an AP Controller) if
it cannot find an AP Controller within one minute of booting up. The Access
Point's Status LED will blink green in a repeating pattern (the LED will remain on
for two seconds and then turn off momentarily). Refer to Chapter 4 for information
on how to configure the Access Point.

Mounting Option

The Harmony 802.11b Access Point is designed to sit on a desktop. In addition, an
optional mounting bracket is available for purchase so that the unit may be mounted to a
wall or ceiling.
Follow these steps to attach the mounting bracket to the Access Point:
1. Remove the two rubber feet on the bottom of the AP. Note that the rubber feet are
attached to the unit with an adhesive.
2. Underneath the rubber feet there are three unthreaded holes that accept M5 thread
forming screws. Align the holes of the mounting bracket with these holes.
3. Locate the screws provided with the mounting bracket.
4. Insert the screws into the three holes of the mounting bracket and AP (that is, the
holes aligned in Step #2 above).
5. Tighten the screws with a screwdriver to attach the mounting bracket to the AP.
14