Proxim Harmony 8550 Manual page 16

Status LED
The Ethernet LED is located on the left side of the Access Point's top panel (with the
unit orientated so that you can read the Proxim logo).
The following table describes the behavior of the Status LED.
LED Behavior Status
Off Unit is not powered on
AP is either
1) initializing or
Solid Amber
2) not partnered with
an AP Controller
AP requires a new firmware
Blinking Amber
image; see Chapter 9
AP is partnered with an AP
Solid Green
Controller and is operational
Blinking Green AP is in Indepedent mode and is
(2 seconds on, then 1 blink) operational
A problem has occurred; see
Blinking Red Chapter 9 for an explanation of the
blinking patterns
Radio LED
The Radio LED is the middle LED on the Access Point's top panel and blinks green
when the Access Point receives data packets over its radio.
Ethernet LED
The Ethernet LED is located on the Access Point's top panel to the right of the Radio
LED (with the unit orientated so that you can read the Proxim logo) and blinks green
when the Access Point receives data packets over the 10Base-T Ethernet port.
16