Regulatory And Safety Information - Palm Pre 2 User Manual

Regulatory and Safety Information

Table 1. Caution icons
Icon Description
Read the Safety Information
section of this user guide
Do not use hand-held while
driving
For body-worn operation
maintain a separation of 1.5 cm
Small parts may cause a choking
hazard
This device may produce a loud
sound
Keep away from pacemakers and
other personal medical devices
Switch off when instructed in
hospitals and medical facilities
Switch off when instructed in
aircrafts and airports
Switch off in explosive
environments
Icon Description
Do not use while re-fuelling
This device may produce a bright
or flashing light
Do not dispose of in a fire
Avoid contact with magnetic
media
Avoid Extreme Temperatures
Avoid contact with liquid, keep
dry
Do not try and disassemble
Do not rely on this device for
emergency communications
Only use approved accessories
FCC Statements
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This phone meets the FCC Radiofrequency Emission Guidelines and is certified with the FCC as:
FCC ID for UMTS-EU: O8F-ROAY
FCC ID for UMTS-NA: O8F-ROAU
The FCC ID on your Palm phone is located on a label inside the battery compartment. The
battery must be removed as shown below to view the label.
Regulatory and Safety Information 237