Palm Pre 2 User Manual page 209

Palm pre 2: user guide
Hide thumbs Also See for Pre 2:
Table of Contents

Advertisement

10
Position the back cover over the phone and gently press the two clasps
(a), located at the top corners. Then press the two clasps (b) halfway
down either side of the phone.
11
Slide out the keyboard (see
Slide out the
two clasps (c) at the bottom corners.
keyboard), and then press the
12
Press and hold the
power
phone until you see a logo on the screen (approximately five seconds).
Then wait until your phone completes setup.
If your phone does not turn on after you insert the battery and press and hold
TIP
power, you may need to charge the battery (see
I inserted or removed the SIM card without taking out the
battery—now I can't connect to the network.
If you inserted or removed the SIM card before you removed the battery,
your phone cannot connect to the network. To restore the network
connection, do the following:
1
Remove the battery (see
I need to replace the
instructions).
2
Remove the SIM card.
3
Reinsert the SIM card.
4
Replace the battery and the back cover (see
battery, steps 9–12, for instructions).
5
Press and hold the
power
phone until you see a logo on the screen (approximately five seconds).
Then wait until your phone completes startup.
6
If Airplane Mode appears in the upper-left corner of the screen, open
the
connection menu
and tap
button on the upper-right corner of your
Charge the
battery).
battery, steps 1–8, for
I need to replace the
button on the upper-right corner of your
Turn off Airplane
Mode.
Chapter 12 : Troubleshooting
209

Advertisement

Table of Contents
loading

Table of Contents