Table of Contents
Advertisement
8
Position the back cover over the phone and gently press the top two
clasps (a), located at the top corners. Then press the two clasps (b)
halfway down either side of the phone.
9
Slide out the keyboard, and then press the two clasps (c) at the bottom
corners.
18
Chapter 2 : Basics
10
Press and hold the
power
button
phone until you see a logo on the screen (approximately five seconds).
Your phone need a few seconds to start up.
If your phone does not turn on after you insert the battery and press and hold
TIP
power, you need to connect your phone to the AC charger to charge it.
11
Follow the onscreen instructions to complete setup.
12
To create a Palm profile, enter a working email address, create a
password for your profile, and select and answer a security question.
IMPORTANT
Be sure to write down the email address and password that you
use to create your profile; you will need them later.
NOTE
If you have a Palm profile from an old webOS phone that you no longer
use, you can enter that profile email address and username to download that
profile information to your new phone. But you can't use the same profile on two
webOS phones at the same time.
13
Your phone is ready to use. To learn how to make your first call, see
Make
calls.
Verify your profile
After you finish setup, look for an email on your computer at the address you
used for your Palm profile. If you don't see the confirmation email in your
Inbox, check your spam mail folder in your desktop email program. Click the
link in the email to do the following:
•
Verify your Palm profile.
•
Follow a link to learn about getting data like contacts and appointments
onto your phone from your desktop organizer software (see
from a desktop organizer on your
on the upper-right corner of your
Export data
computer).
Advertisement
Table of Contents
