Use Gestures: Tap, Swipe, Drag, Flick, Pinch - Palm Pre 2 User Manual

When your phone locates a signal, your wireless service provider name
appears in the upper-left of the screen in the Launcher, Card view, and
Phone, and the signal-strength
* These indicate that wireless services are on.
When you are inside a coverage area, the bars of the signal-strength
icon are filled in according to the strength of the signal. If you're outside a
coverage area, the bars in the signal-strength icon appear dimmed with
an X.
Shut down your phone
Usually, turning your phone off and/or putting it in airplane mode is
sufficient for normal periods when you have the phone with you but you're
not using it. On rare occasions, however, you may want to put your phone
into deep sleep because you are not going to use it for an extended period.
22 Chapter 2 : Basics
icon appears at the top of the screen.
At those times, shut down the screen and wireless services completely by
doing one of the following:
• Open Device Info and tap Reset
Shut Down again.
• Press and hold power , and tap Power. Tap
Battery, and tap Shut Down.
NOTE When you turn everything off, the phone's alarms, ringer, and notifications
are also turned off.
To turn both the screen and wireless services back on, press and hold
until a logo appears onscreen.

Use gestures: tap, swipe, drag, flick, pinch

Gestures are an important, basic part of your phone. They're easy to learn,
and they make working with the phone fast. You make most gestures with
one finger. For a few, you need two. Make gestures with the tip of your
finger. Do not use your fingernail. Don't bear down.
Options. Tap Shut Down, and tap
Shut Down/Swap
power