Table of Contents
Advertisement
Tighten up the Set Screw on the Boss part of the Z Screw.
8
It is necessary to fix the Set Screw against the
D-Cut part of the Z Motor Shaft.
At the same time, please be careful if the top of
the Z Motor Shaft hit the Z Screw.
Tighten the 2 Screws on the Z Screw Support temporarily.
9
Then, tighten up the 2 Screws on the upper part of the Z
Motor Base by rotating the Z Screw and making the Z Slider
downward.
Tighten up the 2 Screws on the lower part of the Z Motor
10
Base by rotating the Z Screw and making the Z Slider
upward.
Tighten up the 2 Screws on the Z Screw Support by rotating
11
the Z Screw and making the Z Slider downward.
Then, apply the grease on the Z Screw and make sure that
the Z Slider moves smoothly.
<Top View>
Set Screw
Z Motor Shaft
Screws
3 Replacement of Main Parts
D-Cut Part
Boss Part of the
Z Screw
<View Point>
3
47
Advertisement
Table of Contents
