Put through the Y Motor Pulley to the Drive Belt and tighten
6
the Flange with the Motor temporarily.
Attach the Spring and tighten up the screws.
7
Then, connect the Y Motor Cable.
<Y Axis Load Check>
Turn on the Power while pressing the [
8
keys too enter the Service Mode.
Select the [LOAD] menu by pressing the [MENU] key and
press [ENTER] key.
Select the [AXIS Y] in the [LOAD] menu and press [ENTER]
9
key. Then, Carriage moves to the Limit Position.
Enter the value 500 and press the [ENTER] key.
Drive
Belt
Spring
], [
], [
]
3 Replacement of Main Parts
[ ], [ ], [ ] + POWER ON
[MENU] key
CHECK MODE
LOAD
CON.
CARD
[ENTER] key
AXIS
X Y Z S
[ENTER] key
AXIS
X Y Z S
VALUE 500
[ENTER] key
AXIS
X Y Z S
VALUE 500
OK
3
43