Table of Contents
Advertisement
3 Replacement of Main Parts
When the Pressing Force matches with the Bending
7
Amount, tighten up the Screw1 and Screw2. Then, carry out
the X Axis Load check.
If the Pressing Force does not match with the Bending
Amount, adjust the Belt Tension by Nut1 and 2 again. After
that, measure the tension and when the Belt Tension
becomes to the proper value, tighten up the Nut1 and 2.
3
<Right Angle Adjustment of X Axis>
After carrying out the Y Belt Tension Adjustment, carry out
8
the Right Angle Adjustment of X Rail.
Loosen the Set Screws of the Y Drive Pulley.
Move the X-Rail to the Rear side frame.
9
Tighten the Set Screws by pushing the X Rail to rear side
10
frame.
Make sure that the Y Drive Pulley won't idle.
66
Screw2
Screw1
Nut1
Y Drive Pulley
Set Screws
Y Drive Pulley
Set Screws
Frame
Nut2
Advertisement
Table of Contents
