Table of Contents
Advertisement
3 Replacement of Main Parts
Push the X-Belt with the Tension Gauge (ST-001) at the
12
center position of the X Belt and check the bending amount
with the ruler.
Confirm that the Pressing Force matches with the Bending
Amount in reference to the next table.
3
When the Pressing Force matches with the Bending
13
Amount, tighten up the Screw1 and Screw2. Then, carry out
the X Axis Load check.
If the Pressing Force does not match with the Bending
Amount, adjust the Belt Tension by Nut1 and 2 again. After
that, measure the tension and when the Belt Tension
becomes to the proper value, tighten up the Nut1 and 2.
<X Axis Load Check>
Turn on the Power while pressing the [
14
keys to enter the Service Mode.
Select the [LOAD] menu by pressing the [MENU] key and
press [ENTER] key.
62
ST-001
EGX-600
EGX-400
Nut2
], [
], [
]
X Belt
<Reference Table>
Pressing Force Bending Amount
720gf
10.0mm
720gf
7.0mm
Nut1
Screw2
Frame
Screw1
[ ], [ ], [ ] + POWER ON
[MENU] key
CHECK MODE
LOAD
CON.
CARD
[ENTER] key
Advertisement
Table of Contents
