Table of Contents
Advertisement
EGX-600/400
Emergency Stop to Ensure Safety
User
The machine immediately stops operating and quits engraving by pressing the
Explanation
emergency stop switch.
Operation
Switching the Power On and Off
Moving the Spindle Head
The speed of movement is determined by how you press the movement buttons.
This machine has the function that moves the spindle head directly to the back-left
position of the table (the VIEW position).
Starting and Stopping Spindle Rotation
To adjust the spindle rotating speed, you use the dial on the operation panel.
Menu Operations
Selecting the Cutter Installation Method
1. Character cutter , Flat cutter (with nose unit)
2. Character cutter , Flat cutter (without withoutse unit)
3. Diamond scraper (without withoutse unit)
4. End mill (without withoutse unit)
Loading Material and Setting the Reference Point for Cutting
1. Clamp
2. Adhesive sheet
3. Center vice
The reference point for engraving is the location where the X- and Y-axis
coordinates are both (that is, the X- and Y-axis origin point).
Setting the Cutting Parameters
There are five kinds of settings and you can make the settings for these either on
the machine by using the menus, or by using the program.
1. Spindle rotating speed
2. Feed rate in the X- and Y- axis directions
3. Feed rate in the Z-axis direction
4. Cutting depth (Z1)
5. Amount of cut-out during feed while raised (Z2)
Installation and Setup the Software
Coordinate Systems
Detailed Description of the Menus
EGX-600/400
Daily Care
User
Clean the table, bed, the spindle head and the X-axis rail.
Explanation
Maintenance and Inspection
Maintenance
Spindle Maintenance
Examples of Setting for Engraving Parameters
Others
The Nose Unit
Optional Items
7 Service Activities
7
97
Advertisement
Table of Contents
