Victron energy Venus GX Manual page 86

4. Remote VEConfigure (DEPRECATED)
Note that this feature is deprecated; and only works for GX devices running v2.16 or earlier. To
remotely configure inverter/chargers in system with GX devices running Venus OS v2.17 or later, see
the functionality, as documented here: VRM Remote VEConfigure.
4.1 Requirements
Remote VEConfigure works for both single unit systems as parallel and three phase systems.
Remotely changing Assistant configuration is possible.
VE.Bus firmware versions 416 and 417 can not be configured remotely
Remote configuring firmware version 418 or later requires the CCGX or Venus GX to run v2.10
or later
The firmware version of the VE.Bus system must stay the same, in between downloading,
changing and uploading settings.
Using a VE.Bus to VE.Can interface?
If the VE.Bus device is connected to the CCGX via a VE.Bus to VE.Can interface, as was often the case
in a Hub-1 system, this interface cable needs to run firmware version v2.05 or higher. Note that it is
possible to first update the firmware in the interface cable, and then remotely configure the VE.Bus
system.
4.2 Instructions
1. Download and install VE Power Setup from our Software downloads page.
2. Obtain the necessary firmware file on the Victron Professional portal]].
3. Follow the Two-way communication checklist.
4. Start VE Power Setup
5. Click "Connected to a Color Control on VRM", and enter your VRM login credentials
6. Choose the required installation. Sites on which you have Admin-rights and that have two-way-
communication enabled will be highlighted in blue:
7. After selecting the site, VE Power Setup will establish communication to the selected site.
8. Once established, it will perform a remote scan, to find all products connected to the Color
Control.
9. Now select the product you want to configure:
VE Power Setup manual