Victron energy Venus GX Manual page 31

...but not on:
iPhone 5s with iOS 8.1.1
1.6.5 IP Configuration
Almost no installations will need the IP address configuration to be inserted manually as most systems
support automatic IP configuration (DHCP) - and that is also the CCGX default setting. If you do need
to configure the address manually, select the following template:
Complete details of IP requirements, as well as used port numbers will be found in the VRM FAQ -ports
and connections used by the CCGX.
1.6.6 Connecting both Ethernet and Wi-Fi (failover)
It is possible to connect the CCGX to both Ethernet and Wi-Fi. In this case, the CCGX will try to
determine which interface provides an active internet connection and then use that interface. When
both have an active internet connection, the Ethernet connection is used. The CCGX will automatically
check again for active internet connections when something changes on the interfaces.
1.6.7 Minimize internet traffic
In situations where internet traffic is expensive, for example a satellite uplink or with roaming
GSM/cellular charges, you may want to minimize the internet traffic. The steps to take are:
Disable auto-update
Do not enable remote support
Reduce the Logging interval to a very low frequency. Note that state changes (charging →
inverting, or bulk→float) and also alarms will cause extra messages to be sent
To find out how much data allowance you need to buy the best way is to let the system run for a
couple of days and monitor the internet RX and TX counters in your 3G or 4G router. Or even better,