Table of Contents
Advertisement
Powering Up the EasyIP System
Vaddio recommends making all connections while the EasyIP Switch is turned off. To power the system,
turn on the EasyIP Switch.
Systems built around an EasyIP Decoder: The device's status light turns blue when the device is
n
ready.
Systems built around an EasyIP Mixer: The power light in the Reset button illuminates immediately
n
when power is connected. The device's web interface is available after it finishes booting. This takes
about 20 seconds.
The EasyIP cameras initialize if they are powered from the same PoE+ switch. This takes a few
n
seconds. The cameras are ready to accept control information when they finish initializing.
Note
No video is available from the EasyIP system until it is configured and at least one camera is paired to the
host device.
Next Steps
Refer to the Complete Manual for the EasyIP System for information on initial device set-up and pairing
cameras to the host device.
Vaddio is a brand of Legrand AV Inc.·
Fax +1.763.971.4464 · Email av.vaddio.support@legrand.com·
Vaddio is a registered trademark of Legrand AV Inc. All other brand names or marks are used for
identification purposes and are trademarks of their respective owners. All patents are protected under
existing designations. Other patents pending.
©2022 Legrand AV Inc.
Installation Guide for the EasyIP 30 ePTZ AV-over-IP ePTZ Camera
www.legrandav.com
· Phone 800.572.2011 / +1.763.971.4400 ·
Advertisement
Table of Contents
