Tunstall Lifeline Digital Installation Manual page 88

Hide thumbs Also See for Lifeline Digital:
Table of Contents

Advertisement

The activation time starts when the care recipient gets out of bed. If the care recipient returns to bed before
the activation time has elapsed, no alarm is generated.
iii. Set the initial absence time to delay VIBS activation in the Initial absence time (seconds) field.
The initial absence time delays VIBS activation in case the care recipient goes to bed later than expected.
iv.
Select which alarm or event to generate when the initial absence time elapses in the Alarm type for initial
absence timeout field.
d)
Under Bed sensor > Entering bed, enable the bed sensor to detect when a care recipient gets into bed:
i.
Select the position of the bed sensor in the Radio sensor drop-down list.
ii.
If required, select sensor trigger type in the Trigger type drop-down list. Otherwise, select "Any" to keep
settings from the selected radio sensor.
iii. If required, select location of the sensor in the Location drop-down list. Otherwise, select "Any" to keep
settings from the selected radio sensor.
The guard time starts when a care recipient gets into bed. If the care recipient gets out of bed before the guard
time has elapsed, VIBS is not activated.
e)
Under Bed sensor > Leaving bed, enable the bed sensor to detect when a care recipient gets out of bed:
i.
Select the position of the bed sensor in the Radio sensor drop-down list.
ii.
If required, select sensor trigger type in the Trigger type drop-down list. Otherwise, select "Any" to keep
settings from the selected radio sensor.
iii. If required, select location of the sensor in the Location drop-down list. Otherwise, select "Any" to keep
settings from the selected radio sensor.
The activation time starts when the care recipient gets out of bed. If the care recipient returns to bed before the
activation time has elapsed, no alarm is generated.
88

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents