Configuring Lifeline Digital Using Dmp; Log In To Dmp And Access Device Settings - Tunstall Lifeline Digital Installation Manual

5. Configuring Lifeline Digital using DMP

This chapter describes how to configure Lifeline Digital using Tunstall's Device Management Platform (DMP).
Make sure that you have read the document and are familiar with the installation and configuration process. Typically,
not all sections in this document will be relevant to your case. Omit sections and settings that are already pre-config-
ured or does not apply to your case.
To configure Lifeline Digital using DMP you require:
• a username and password
• a list of all values and parameter settings to be configured. Do not change any settings or values unless advised by
your supplier or Tunstall.
• If your organization enforce two-step verification, you must set up Google Authenticator, for more information refer
to DMP User manual.
It is recommended that you carry out as much of the configuration as possible before installing the device on-site.
Updates and changes are deployed from DMP to the device whenever the device connects to DMP, either automati-
cally at a heartbeat or online poll, or when you manually connect to DMP.
Contact your supplier or Tunstall if you have any questions.

5.1. Log in to DMP and access device settings

To log in to DMP and access device settings:
a) Go to the DMP login page.
The web address (URL) is provided by your organisation, supplier or Tunstall.
NOTE
Bookmark the web address (URL) for faster access in the future.
b) Enter your username and password then click LOGIN
DMP opens the Start page.
c) Under My Districts, click on the district that you want to view, or click Devices in the sidebar menu.
DMP opens the Devices page and displays a list of devices.
d) You can search, sort and filter the list:
48