Tunstall Lifeline Digital Quick Start Manual
  1. Manuals
  2. Brands
  3. Tunstall Manuals
  4. Switch
  5. Lifeline Digital
  6. Quick start manual

Tunstall Lifeline Digital Quick Start Manual

Hide thumbs Also See for Lifeline Digital:
Table of Contents

Advertisement

Quick Links

Download this manual
Lifeline Digital
Art. 022-25-9xx
Quickstart guide
DMP
English
Doc 346 80 21-69. Version 2 Revision 01.2023 - SW

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Lifeline Digital and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Tunstall Lifeline Digital

Summary of Contents for Tunstall Lifeline Digital

  • Page 1 Lifeline Digital Art. 022-25-9xx Quickstart guide English Doc 346 80 21-69. Version 2 Revision 01.2023 - SW...
  • Page 2 Please Note: This an international guide and may contain features and functions not currently available in your region. Please contact your Tunstall Healthcare representative for more information.

  • Page 3: Table Of Contents

    Table of Contents 1. Overview ..............................4 1.1. Version ..............................4 2. Install Lifeline Digital ............................ 5 3. Connect a peripheral ........................... 7 4. Device Management Platform (DMP) ......................8 4.1. Log in to DMP and access device settings ....................8 4.2.

  • Page 4: Overview

    1. Overview 15 16 1. Red Alarm button 7. NFC 13. Antenna connector 17. Cable slot 2. Green Cancel button 8. Microphone 14. 2x USB 2.0 ports 18. Security screw (T10) for battery slot 15. Ethernet/network con- 3. Yellow Extra button 9.

  • Page 5: Install Lifeline Digital

    Screw the security screw back in place using the For Ethernet/wired IP connectivity, connect Lifeline T10 torx screwdriver. Digital to a local router or Ethernet socket: Connect Lifeline Digital to mains power: Insert an Ethernet cable into the Ethernet/Net- work (RJ45) connector on the device (2). CAUTION...
  • Page 6 Press the green Cancel button (14) again to exit programming mode. If the device is registered to Tunstall's Device Man- Release all buttons when the device emits a ris- agement Platform (DMP), you can manually connect ing sound signal and announces "Programming...

  • Page 7: Connect A Peripheral

    3. Connect a peripheral Press and hold the green Cancel button (1) then • Continue to hold the button until the device an- press and hold the red Alarm button (2) and the nounces the number of the radio sensor position yellow Extra button (3).

  • Page 8: Device Management Platform (Dmp)

    4. Device Management Platform (DMP) Tunstall’s Device Management Platform (DMP) is a cloud-based system that provides remote management, config- uration and monitoring of connected devices. From DMP it is possible to manually configure settings or apply preconfigured templates to one or several devices. DMP can also distribute configuration and firmware updates.

  • Page 9: Common Settings

    ARC where the device is located. 4.3. Configure cellular network settings and Access Point Name (APN) CAUTION Do not change settings or values unless advised by your supplier or Tunstall. Unauthorized changes may disrupt communication and cause connectivity failure. To configure cellular network settings: Activate PIN code in the PIN mode drop-down list.

  • Page 10: Configure Device Connectivity Methods

    Enter the IP address or FQDN of the receiver in the quence. Address field. Select a communication protocol in the Protocol Set the number of connection attempts to be made drop-down list: for this address in the No. of attempts field. • Tunstall IPACS • SCAIP • Homephone-SIP • EN50134-9...

  • Page 11: Configure Sip Accounts

    • Cellular NOTE • WLAN (Wi-Fi), additional configuration is required strongly recommends at least 5 con- under GPRS/IP > IP/WLAN nection attempts for each address to • Auto, the system automatically determines con- ensure stable operation in case of nection type temporary interference.

  • Page 12: Save Settings

    Set the number of redial attempts to be made in If required, tick the Registration checkbox to use SIP the Dialout phone retries field. registration. If required, enter the SIP Realm/domain in the Realm If required, tick the Encryption checkbox to use en- field.

  • Page 13: Contact Details

    Appendix A. Contact details Head office - United Kingdom Emergency Response Ltd +45 87 93 50 00 Ryland Road Tunstall Healthcare (UK) Ltd dk.info@tunstall.com Bunclody Whitley Lodge www.tunstall.dk Enniscorthy Whitley Bridge County Wexford Yorkshire Ireland DN14 0HR Finland United Kingdom 00 353 53 937 6400 sales@emergencyresponse.ie...
  • Page 14 Vitaris Response B.V. Oslo 26 Nederland 2993 LD Barendrecht Sverige PO Box 311 Tunstall B.V. 2990 AH Barendrecht Tunstall AB Oslo 28 The Netherlands Box 31044 2993 ld Barendrecht 200 49 Malmö The Netherlands +31 55 539 54 00 Sweden info@vitaris.nl...
  • Page 15 © 2023 Tunstall Group Ltd. ® Tunstall is a registered trademark. Tunstall declare that this radio equipment is in compliance with Directive 2014/53/EU. The full text of the EU declara- tion of conformity is available at the following address: https://www.tunstall.com/lifeline-digital-documentation...

Table of Contents