Starting The Device - H3C ICG2000 Installation Manual

Starting the device

WARNING!
Before powering on the device, locate the switch for the power source so that you can cut off
power promptly in case of an emergency.
NOTE:
To access the device when it starts up with the factory-default configuration, you must press
CTRL+D.
To start the device:
1. Verify the installation and the configuration environment is as described in
installation."
2. Power on the device.
3. During the booting process, verify the following items:
The LEDs on the front panel are in the states as described in Table2-2.

Table2-2 LED states when the device is operating correctly
LED
PWR
SYS
The configuration terminal displays information correctly.

The device first initializes its memory at startup. Then it runs BootWare.
System is starting...
Press Ctrl+D to access BASIC-BOOTWARE MENU...
Booting Normal Extended BootWare
The Extended BootWare is self-decompressing....Done.
****************************************************************************
*
*
*
****************************************************************************
Copyright (c) 2004-2017 New H3C Technologies Co., Ltd.
Compiled Date
CPU ID
CPU L1 Cache
CPU L2 Cache
Memory Type
Memory Size
Flash Size
CPLD Version
PCB Version
State
Steady green
Slowly flashing green
H3C ICG2000D BootWare, Version 1.02
: Sep 18 2017
: 0xc
: 32KB
: 1024KB
: DDR3 SDRAM
: 1024MB
: 256MB
: 131.0
: 2.0
2-12
Description
The power system is operating correctly.
The device system is operating correctly.
"Verifying the
*
*
*