Table of Contents
Advertisement
ASSEMBLY
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
• After shipping, there may be an oily substance
on the exterior of the treadmill. This is normal. If
there is an oily substance on the treadmill, wipe
it off with a soft cloth and a mild, non-abrasive
cleaner.
• To identify small parts, see page 6.
1. To register your product and activate your
warranty in the UK, go to iconsupport.eu. If you
do not have internet access, call Member Care
(see the front cover of this manual).
To register your product and activate your
warranty in Australia, email or post the
following information to the email address or
postal address on the front cover of this manual.
• your receipt (make sure to keep a copy)
• your name, address, and telephone number
• the model number, serial number, and name
of your product (see the front cover of this
manual)
2. Make sure that the power cord is unplugged.
Carefully raise the Right Upright (81) to the verti-
cal position.
Next, start a 3/8" x 2 1/4" Screw (1) and a
3/8" x 3/4" Screw (3) into the Base (90) and the
Right Upright (81) as shown; start both Screws,
and then tighten them.
Repeat this step on the left side of the
treadmill.
• Left parts are marked "L" or "Left" and right parts
are marked "R" or "Right."
• Assembly requires the following tools:
the included hex keys
one Phillips screwdriver
To avoid damaging parts, do not use power tools.
1
2
7
81
1
3
90
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Cadence Compact 500 and is the answer not in the manual?
Questions and answers
My cc500 treadmill is squeaking. Do I need to lubricate it and where?
The Pro-Form Cadence Compact 500 treadmill has a walking belt coated with high-performance lubricant. The manual explicitly states not to apply silicone spray or other substances to the walking belt or walking platform unless instructed by an authorized service representative. If the treadmill is squeaking, lubrication should not be applied unless advised by the manufacturer. Instead, check for other possible causes, such as loose parts or misalignment.
This answer is automatically generated
how do you know how many miles are on the machine?
To check the mileage on a Pro-Form Cadence Compact 500, look at the display and find the "Distance" reading, which shows how far you have walked or run in miles or kilometers. If needed, you can change the unit of measurement by pressing the "St/M" button.
This answer is automatically generated