Table of Contents
Advertisement
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing matedals. Do not
dispose of the packing materials until assembly is completed. Assembly requires your own Phillips screw-
driver (IMP3======- and rubber mallet c:::_.
Note: The underside of the treadmill walking belt is coated with high-performance
lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
1. With the help of a second person, carefully raise the
treadmill to the upright position as shown. If there are
plastic ties on the pulse sensors, remove them.
Insert one of the Extension Legs (55) into the treadmill as
shown. Make sure that the Extension Leg is turned so
the Base Pad (44) is on the bottom. If necessary, tip the
Uprights (64) forward as you insert the Extension Leg.
Insert the other Extension Leg (not shown) in the same
way.
44
2. With the help of a second person, carefully lower the
Uprights (64) as shown. Note: It may be helpful to place
your foot on one of the Wheels (58) as you tip the
Uprights. Make sure that the Extension Legs (55) _-
main in the Uprights.
Attach each Extension Leg (55) with an Extension Screw
(35), a 1" Screw (13), and a Base Pad (44) as shown.
Note: One replacement Base Pad (44) may be included.
If a Base Pad becomes worn and needs to be replaced,
use the replacement Base Pad.
o
55
55 --_4.4_""_
13
\\\t\\\\\\\l
6
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 520X and is the answer not in the manual?
Questions and answers
I want to get the base off of the ProForm 520x, and get it out of my basement. It does not work.So basically disassemble for moving purposes.
To disassemble the Pro-Form 520X treadmill for moving, follow these steps:
1. Lower the Incline: Adjust the treadmill to the lowest incline position to prevent damage.
2. Unplug the Power Cord: Disconnect the treadmill from the power source.
3. Fold the Treadmill:
- Hold the treadmill at the designated locations.
- Bend your legs and keep your back straight to avoid injury.
- Lift the treadmill using your legs.
- Move your right hand to the appropriate position and hold firmly.
- Use your left hand to pull the latch knob to the left and hold it.
- Raise the treadmill until the catch passes the latch pin.
- Slowly release the latch knob, ensuring the catch is securely held by the latch pin.
4. Protect the Floor: Place a protective material under the treadmill to prevent floor damage.
These steps allow you to safely prepare the treadmill for moving.
This answer is automatically generated