Advertisement
ASSEMBLY
Assembly requires
two persons.
Set the treadmill in a cleared area and remove all packing materials; do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is
coated with high-performance
lubricant. During shipping, a small amount of lubricant may be transferred to the
top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-
mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
non-abrasive cleaner.
Assembly requires the included allen wrenches
_ and your own phillips
screwdriver
_,
rubber mallet c:::::z:z_,
and adjustable
wrench _.
For help identifying the assembly
hardware, see the drawings
below, if a part is not in the parts bag, first
check to see if it has been pre-assembled, if a part is missing,
call toll=free 1=888=533=1333.
1/2" Screw (48)-2
Small Star
Handrail Star
Washer (24)-4
Washer (95)-2
Silver Ground
3/4" Tek Screw
1" Tek Screw (39)-4
Screw (75)-1
(58)-2
Nut (13)-2
Extension Leg
Nut (46)-4
Extension Leg Bolt (93)-4
3/4" Screw (2)-9
Wheel Bolt (64)-2
Handrail Bolt (37)-2
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip the
treadmill onto its left side as shown. Partially fold the
Frame (86) so the treadmill is more stable. Do not fully
fold the treadmill
until it is completely
assembled.
Insert an Extension Leg (63) into the base of the
Uprights (69), with the Extension Leg Pad (61) oriented
as shown. If necessary, use a rubber mallet to fully insert
the Extension Leg. Next, hold two Extension Leg Nuts
(46) in the bottom of the Extension Leg, and insert two
Extension Leg Bolts (93) into the top of the Extension
Leg. Firmly tighten the Extension Leg Bolts into the
Extension Leg Nuts.
Attach two Base Pads (57) to the base of the Uprights
(69) with two 1" Tek Screws (39).
1
86
69
57
Y
Advertisement
