Assembly - Pro-Form 595LE User Manual

i
ASSEMBLY
Assembly requires tw_ people. Set the treadmill in a cleared area and remove all packing rnatedals. Do not .
dispose of the packing materials until assembly is completed. Assembly requires the Included ellen wrenc.._
and your own phillips screwdriver (_:_-==-,---, adjustable wrench _ and scissors
1. With the help of a second person, carefully raise the
treadmill to the updght position. While the other person
tips the treadmill to one side and holds It, Insert one of
the Extension Legs (103) into the tmadmllL Make sure
that the Extension Leg Is tumed so the Waming Decal
(20) is on top. Tighten two of the four Short Screws
(101) into the treadmill and the Extension Leg.
Next, tip the treadmill to the other side and attach the
other Extension Leg (not shown) in the same way. Lower
the side of the treadmill so that both Extension Legs
(103) are resting fiat on the floor.
2. Refer to HOWTO LOWER THE TREADMILL FOR
USE on page 11. Follow the instructions in step 2 to
lower the treadmill
Without removing the tape from the Latch (77), attach
the Latch to the left Upright (82) with two 3/4" Screws
(81). Make sure that the Screws ere tight, but do not
overtlghten them; ff the Screws are overtightened,
the Latch will not slide smoothly. After the Latch is
attached, remove any visible tape.
Note: The Insetdrawingshowshow the partsof the
Latch (77) f'dtogether.
3. Cut the plastic tie off the bracket on the base of each
Upright (82).
Next, cut the plastic tie off the Left Handrail (74).
Position the Left Handrail on the left Updght (82). The
bracket on the base of the left Upright should be Inside
of the lower end of the Left Handrail, as shown in the
inset drawing.
1
20
103
101
5