Changing The Scancode Set Of Ps/2 Keyboards - G&D VisionXS-IP-F-DP-UHR Installation And Operation Manual

Configuration

Changing the scancode set of PS/2 keyboards

If you press a key at the PS/2 keyboard, the keyboard processor sends a data packet
that is called scan code. The two common scancode sets (sets 2 and 3) contain differ-
ent scancodes.
In the default configuration, the KVM extender interprets any entry made at the PS/2
keyboard with the scancode set 2.
Use the scancode set 3 if you cannot enter the pipe "|" or the arrow keys do not
work as expected.
How to change the setting of the scancode set:
1. Press
Ctrl+Num
Select the row
2. Under
Scancode set
 activates scancode set 2 for PS/2 keyboard inputs
2
 activates scancode set 3 for PS/2 keyboard inputs
3
3. Press F2 to save your settings.
After you turn the KVM extender on again, the keyboard is initialised and the
selected scancode set is applied.
85 · G&D VisionXS-IP-F-DP-UHR
(default) to open the OSD.
Console setup and press
press to select one of the following options:
F8
Enter .