Configuration Settings; Operating Modes Of Console Modules - G&D VisionXS-IP-F-DP-UHR Installation And Operation Manual

Configuration

Configuration settings

Operating modes of console modules

Depending on the application of the KVM extender, you can select one of the fol-
lowing operating modes:
 OpenAccess mode:
authentication.
NOTE: This operating mode is set by default.
You can configure the same access rights for both a KVM extender and a user
account.
IMPORTANT: The configured access rights apply to all users working with this
KVM extender.
 Standard mode: The default mode allows access to the KVM extender only after
users are authenticated with their username, password, and 2-factor authentication
if set up.
NOTE: This operating mode is set by default, if you use the extender as a
switch module (see Use as extender or matrix switch modules on page 5).
User rights can be configured in the individual user account.
How to select the operating mode of the KVM extender:
1. Press Ctrl+Num
2. Select the row
3. Under Console type
OpenAccess
Standard
4. Press to save your settings.
F2
71 · G&D VisionXS-IP-F-DP-UHR
In this mode, access to the KVM extender is not protected by
(default) to open the OSD.
and press
Console setup
, select one of the following options:
 OpenAccess mode (default)
 Standard mode
.
Enter
matrix