Prioritizing A Usb Device For A Reboot - G&D VisionXS-IP-F-DP-UHR Installation And Operation Manual

Prioritizing a USB device for a reboot

If multiple USB devices are connected and detected in Generic USB mode, the first
detected USB device will be connected by default after the console module is resbooted. If
both the console module and the computer module support the use of up to five Generic
USB devices, up to five USB devices will be reconnected in the order they are detected.
These devices appear in yellow on the OSD and are marked with an asterisk (
You can specify a USB device that should be prioritized after a reboot and should be
accessible in any case.
How to prioritize a USB device for a reboot:
1. Open the local OSD of the console module by pressing the
(default: Alt+Num
2. Press F11 .
3. Select the
Keyboard/mouse
4. Select the
Generic USB
5. Select the USB device you want to access in any case after the reboot and
press Enter .
This device will now be highlighted in green with a triangle () on the OSD.
6. Press to save your settings.
F2
NOTE: The prioritization remains even if the USB device is disconnected from the
console module (then appears in red on the OSD) and is subsequently recon-
nected (then reappears in green on the OSD and marked with a triangle ()).
).
line and press
line and press
Enter
local hotkey
.
Enter
.
G&D VisionXS-IP-F-DP-UHR · 84
Configuration
).
