Configuring The Network Interface - G&D VisionXS-IP-F-DP-UHR Installation And Operation Manual

Initial configuration of the network settings

Configuring the network interface

How to configure the network interface:
1. Use the
local hotkey
work interface of the console module or use the
open the remote OSD to configure the network interface of the computer module.
2. Select the entry
3. Select the entry
4. Enter the following data under
Operational
mode:
IP address:
Netmask:
5. Press to save your settings.
F2
21 · G&D VisionXS-IP-F-DP-UHR
(default: +
Alt Num
Network setup and press
and press
Interfaces
Interface A
Press F8 to select the operational mode of the interface:
switch network interface off.
 Off:
A static IP address is assigned.
 Static:
IP address is obtained from a DHCP server.
 DHCP:
Enter the IP address of the interface.
The operational mode DHCP does not allow making entries.
Enter the netmask of the network.
The operational mode DHCP does not allow making entries.
) to open the local OSD to configure the net-
remote hotkey
Enter .
.
Enter
:
(default: + ) to
Ctrl Num