Table of Contents
Advertisement
Installation
CHS-M2 Chassis Mounting
The UDACT is installed on a CHS-M2 Chassis within the control panel backbox as described and
shown below:
UDACT Instruction Manual — P/N 50050:M 12/18/2009
Step
Action
1
Disconnect AC power and disconnect batteries.
2
Insert the tab at the bottom of the board into the chassis slot as indicated.
3
Position the UDACT on the standoffs and fasten with #4 screws.
Figure 2.4 CHS-M2 Installation
Fastening holes
Chassis slot
Tab
Installation and Wiring
Metal standoffs
21
Advertisement
Table of Contents
