Replacing An Existing Communicator; Registering By Phone; Diagnostic Commands; Module Identification Displays - Honeywell CDMA-X Installation And Setup Manual

Replacing an existing communicator

This prompt appears after pressing the down arrow [↓] on the 7720P. Enter a 4-digit
Enter PIN#
alphanumeric PIN number provided by your central station, your dealer or an authorized
AlarmNet representative.
Press the [ENTER] key.
The registration message is sent and the unit waits for acknowledgement.
Registering ...
If the PIN is valid, the new communicator is registered and the old unit unregistered.
Registration
Additionally, AlarmNet sends a substitution alarm to the central station.
SUCCESS
If you entered an invalid PIN, the appropriate message is displayed depending on which account
Registration BAD
number is being replaced (see above for exact wording). The registration process is repeated.
NOTE: Each attempt causes a substitution alarm to be sent to the central station.

Registering by Phone

You can register the communicator by calling the AlarmNet Support at 1-800-222-6525 (Option 1). (Monday–Friday 8:00
am to 9:00 pm, Saturday 9:00 am to 5:30 pm ET) You will need the following information:
MAC ID and CRC (located on the box and inside the communicator).
•
Subscriber information (provided by the central station), including a city code, CSID, and subscriber ID.
•
When Instructed to do so, triple click the TEST MESSAGE / REGISTRATION switch.
•

Diagnostic Commands

The 7720P programming tool can be used to view the connectivity settings and options. To invoke diagnostic commands;
such as [A], [B], [C], etc., the [shift] key MUST used. For example, [shift] + [A] displays the software revision.

Module Identification Displays

[A]
CDMA-X RIS
x.x.xx mm/dd/yy
[B]
MAC xxxxxxxx
MAC CRC xxxx
ESN xxxxxxxx
[C]
Mon 01 Jan 2001
05:48:39 AM
[D]
Encryption Test
AES Passed!
CDMA-X Installation and Setup Guide
Software Revision
"x.x.xx" indicates the installed software revision.
Mm/dd/yy indicates month, day and year of the revision.
MAC Address
"xxxxxxxxxxxx" indicates the communicator's unique identification number.
"yyyy" indicates the MAC CRC number. These numbers are located on the box and inside the
communicator.
Press the [Space] key to go to the next field.
Press the [BS] key to go to the previous field.
ESN (Electronic Serial Number)
A unique number that is used by the carrier to enable/disable it from the network.
Press the [Space] key to go to the next field.
Press the [BS] key to go to the previous field.
Time
Retrieves the current date and time from the AlarmNet network in Greenwich Mean
Time (GMT). This display confirms that the communicator is in sync with network.
Encryption Test
Performs a self-test of the AES encryption algorithm.
– 17 –