1: Ademco Contact Id - Honeywell NOTIFIER UDACT Instruction Manual

Reporting Formats
5.1.1 Ademco Contact ID
The reporting structure for the Ademco Contact ID format is as follows:
SSSS 18 QXYZ GG CCC
NOTE: For general reports (alarm, trouble and supervisory), the GG and CCC fields are
transmitted as 00 and 000 unless changes to addresses 64-65 and 66-68 are made.
64 - 65 = Loop number (GG), (factory default is 00)
66 - 68 = Device/Zone number (CCC) for General Alarm, Fault or Supervisory messages (factory
default is 000).
A typical printout of alarm and trouble reports in the Ademco Contact ID Reporting Structure
follows:
Time
11:28
11:28
11:28
11:28
11:28
11:28
11:28
11:28
NOTE: In the sample report, SD46 refers to smoke detector at address 46 or on zone 46.
18, which is used in the reporting structure to identify the transmission as Contact ID, is not
printed out in the alarm and trouble report.
Q, which is the Event Qualifier for the reporting structure, is printed out in the report as an E for
New Event or R for New Restore.
CCCC, the first C is not transmitted by the UDACT but is printed by the Central Station Receiver
printer output.
58
SSSS = Four digit Subscriber ID (addresses 17 - 20 and 43 - 46)
18 = Identifies transmission as Contact ID to the receiver at the
Central Station
Q = Event Qualifier; 1 = New Event, 2 = New Restore
XYZ = Event Code (shown in Table 3.2 to Table 3.7)
GG = Group or Loop number
CCC = Device or Zone number
Table 5.3 Ademco Contact ID Reporting Structure
Rcvr/
Date SSSS
Line ID
10/14 11 7777
10/14 11 7777
10/14 11 7777
10/14 11 7777
10/14 11 7777
10/14 11 7777
10/14 11 7777
10/14 11 7777
QXYX GG CCCC
E110 00 C000
E111 00 C046
E300 00 C000
E380 00 C046
R110 00 C000
R111 00 C046
R300 00 C000
R380 00 C046
UDACT Instruction Manual — P/N 50050:M 12/18/2009
Data Reporting Structure
General Alarm
Alarm SD46
General Trouble
Trouble SD46
General Alarm Restore
Alarm SD46 Restore
General Trouble Restore
Trouble SD46 Restore