Table of Contents
Advertisement
Chapter 5 Troubleshooting the MQAM
Troubleshooting Alarm Messages
If the MQAM displays an alarm condition, fails a self-test, or does not work
properly, refer to the table in this section to find and correct the cause. Some alarm
conditions may require you to contact Cisco Services..
See Troubleshooting Boot Screen Error Messages (on page 79) for resolving
problems encountered during the start-up process.
Front Panel LCD Alarm Messages
The following table lists Alarm Messages displayed on the front panel LCD of the
MQAM, the default level of severity defined for the MQAM, a probable cause for the
alarm, and suggestions for correcting the alarm condition.
Notes:
The LCD descriptions for each alarm are arranged in alphabetical order.
Alarm messages that occur for the four RF outputs or the two ASI input ports are
listed only once. The numbers in parentheses indicate the range of port numbers
that might be affected by the alarm.
Example: The "Input (1-4) errored MPEG packet" description corresponds to the
Input port that is affected.
72
78-717866-01 Rev D
Advertisement
Table of Contents
Troubleshooting
