Displaying Alarm Status; Viewing The Session Count; Viewing The Program Count - Cisco D9477-1 Installation And Operation Manual

Displaying Alarm Status

Follow these steps to display the list of active alarms.
1 Press OPTIONS. The Alarm Status screen appears.
Notes:

Each alarm description appears for approximately 1 second before displaying
the next alarm. If no alarms are active, a No Active Alarms message appears.

See Troubleshooting Alarm Messages (on page 72) for detailed descriptions
of alarms.
2 Press ENTER. The default screen appears.

Viewing the Session Count

The Session Count screen displays the count of all active sessions for the selected RF
output. Follow these steps to view the total number of active sessions.
1 Press OPTIONS until the Session Count screen appears.
Note: The session count for the MQAM will differ from the session count on the
DNCS if the MQAM does not find needed MPEG programs within MPEG
Program Specific Information (PSI). By design, the MQAM responds positively
to a session setup request even if the requested MPEG program is not present on
the input transport stream.
2 Press RF SEL to view the session count for each RF module.
3 Press ENTER to return to the default screen.

Viewing the Program Count

The Program Count screen displays the encrypted programs currently running on
the selected RF output. Follow these steps to view the program count for an RF
module.
1 Press OPTIONS until the Program Count screen appears.
2 Press RF SEL to view the program count for each channel.
Press ENTER to return to the default screen.
3
78-717866-01 Rev D
Monitor Setup Options
55