Record The Mac Address; Recording The Mac Address - Cisco D9477-1 Installation And Operation Manual

Chapter 2 Installing the MQAM

Record the MAC Address

This section contains instructions for recording the Media Access Control (MAC)
address by powering on the MQAM to record the MAC address as part of the
installation process.
Note: Refer to Connect Power Sources (on page 16) before you power up an MQAM
to record the MAC address.

Recording the MAC Address

Follow these steps to power up the MQAM and record the MAC address.
1 Choose one of the following:
 For the 120 or 230V AC MQAM, verify that the power switch on the back of
is placed in the Off position.

For the 48V DC MQAM, verify that the DC power supply is set to the Off
position.
2 Choose one of the following:
 For the 120 or 230V AC MQAM, press the power switch on the back panel to
the On position.

For the 48V DC MQAM, switch the power supply to the On position.
Result: The MQAM begins the boot process during which time it displays the
MAC address.
Example:
3 Record the MAC address when it appears on the front panel LCD.
Notes:

When the MQAM is set to boot mode 2 (default setting), it cycles through the
boot process and displays the MAC Address window repeatedly, as long as
the MQAM is not connected to the network.

If the MQAM is set to boot mode 0 or 1, the MQAM also displays the MAC
address as it boots. After the boot process is complete, the MQAM displays
the default status window.
Example:
Note: After the default status window appears, press the OPTIONS button until
the MAC address displays. See Read the Default Status Screen (on page 47) for
more information.
18 78-717866-01 Rev D