Initial Boot Screens - Cisco D9477-1 Installation And Operation Manual

Understand the Boot Process

Initial Boot Screens

The following illustrations show examples of the initial boot screens.
Note: Actual screen settings may differ from the examples presented in this guide.
When the MQAM boots, the boot code version and release date appear.
After a brief period, the MAC address of the MQAM appears.
If BOOTP completes successfully, the IP address boot screen appears.
Note: Although it is not a typical setting, if the MQAM is set to run in a Standalone
mode (boot mode 0), the following Standalone mode boot screen appears instead of
the "Starting MQAM" boot screen.
The IP address boot screen remains visible for approximately 2 seconds. If no errors
occur and no downloads are attempted, the boot code starts the application code and
a screen similar to the following appears.
Next, a screen similar to the following appears.
Then, the default status screen appears.
78-717866-01 Rev D 43