Connecting The Dvb Asi Ports - Cisco D9477-1 Installation And Operation Manual

Connecting the DVB ASI Ports

Refer to your network wiring diagram to cable the MQAM in accordance with your
bandwidth allocation plan.
Follow these steps to connect each of the DVB ASI Input ports.
1 Locate the DVB ASI I/O Card on the back of an output device, such as a
Grooming BIG or a VOD server.
2 Connect one end of a 75 Ω coaxial cable to a DVB ASI source in accordance with
your network wiring diagram.
Note: The maximum recommended length for the 75 Ω coaxial cable is 100
meters.
Connect the other end of the 75 Ω coaxial cable to the DVB ASI INPUT 1 or the
3
INPUT 2 port on the MQAM.
Note: If you do not use both ASI inputs, the MQAM displays an ASI - Loss of
Input Signal alarm for the unused port.
78-717866-01 Rev D
Connect the DVB ASI Input Ports
23