Viewing The I/O Board Software Revision Level; Viewing The Rf Module Revision Numbers; Checking The Temp Of An Rf Module - Cisco D9477-1 Installation And Operation Manual

Viewing the I/O Board Software Revision Level

The Software Package Release version screen displays the top-level software release
version for the modulator. To display the Software Package Release version screen,
follow these steps.
1 Press OPTIONS until the Software Package Release version screen appears.
Notes:

In the above example, App is the application code and Boot is the boot code.
 This revision number for the application code and boot code, represented in
the above example by X.X.X, contains the major release number, the minor
release number, and the point release number.
2 Press Enter to return to the default screen.

Viewing the RF Module Revision Numbers

The RF Module Revision screen displays the revision numbers for the hardware and
software of the selected RF Module. To display the RF Module Revision screen,
follow these steps.
1 Press OPTIONS until the RF Module Revision screen appears.
Notes:
 SW shows the RF board microprocessor firmware revision displayed as
major release and minor release.

PWB shows the Printed Wiring Board revision of the RF board.

Mode is the PWB assembly of configuration. The 0 indicates a
Standard/Domestic Mode (Baseband to RF Output) PWB assembly.
2 Press RF SEL to display information about each RF module (RF1-RF4).
3 Press ENTER to return to the default screen.

Checking the Temp of an RF Module

1 Press OPTIONS until the Temperature screen appears.
Press RF SEL to display information for each RF module.
2
3 Press ENTER to return to the default screen.
78-717866-01 Rev D
Monitor Setup Options
57