Cisco D9477-1 Installation And Operation Manual page 24

Chapter 1 Introducing the MQAM
Item
7
8
9
10
11
12
8
Component
FREQ
LEVEL
CW
OPTIONS
ENTER
RF SEL
Description
The Frequency key selects the frequency display screen on
which you can adjust the RF output frequency for each of the
RF carriers.
The Level key selects the RF Output Level screen on which
you can adjust the RF output power level and mute the RF
output (42 to 56 dBmV).
The Continuous Wave (CW) key selects the Continuous
Wave Screen on which you can set the modulator to output
either a modulated carrier or a continuous carrier for each of
the RF carriers.
Note: CW mode is used for testing and not for normal
operation.
The Options key scrolls through status information and setup
options.
The Enter key saves configuration changes to nonvolatile
memory.
The RF Port Selection (RF SEL) key selects one of the RF
outputs that is controlled or monitored by the front panel.
78-717866-01 Rev D