Cisco D9477-1 Installation And Operation Manual page 48

Chapter 3 Provision the MQAM
The following table lists field descriptions on the Basic Parameters tab.
Field
Headend Name
QAM Name
IP Address
Physical Address
Subnet Mask
Administrative State
ASI INPUT 1 Transport
Stream ID
ASI INPUT 2 Transport
Stream ID
Transport Stream ID
Modulation Type
Channel Center
Frequency (MHz)
32
Description
The name of the headend with which the MQAM is associated.
The name used for the MQAM.
The Internet Protocol address for the MQAM assigned by the
system administrator.
The MAC address of the MQAM .
IP Subnet Mask. For a class B IP network, the standard mask is
255.255.0.0.
Specifies whether the MQAM is active within the system. The
values are:
Offline - Default

Online - The MQAM is active in the system

Represents the identifier of the MPEG transport stream
generated upstream of the MQAM. A unique value is assigned
to the ASI INPUT 1 port on the MQAM. MQAMs only accept
DVB-ASI input.
Represents the identifier of the MPEG transport stream
generated upstream of the MQAM. A unique value is assigned
to the ASI INPUT 2 port on the MQAM. MQAMs only accept
DVB-ASI input.
The identifier of the MPEG transport stream generated by the
corresponding RF output of the MQAM. A unique value must
be assigned to each of the 4 RF output ports.
Allows you to specify one of five modulation types for each of
the four RF OUT ports. The following modulation types are
valid:
DAVIC 1.0, 16 QAM

DAVIC 1.0, 64 QAM

DAVIC 1.0, 256 QAM

ITUB 64 QAM

ITUB 256 QAM

The frequency assigned to each RF output port (range is 91 to
867 MHz). Valid frequencies use the following format, with X
representing some number:
XXX.000

XXX.25

XXX.75

78-717866-01 Rev D