Table of Contents
Advertisement
P O W E R L I N K I N G
This feature allows multiple units to be linked together by way of the power input and output sockets.
The maximum number of devices that can be connected in this manner is 20 units.
After this quantity has been reached, a new power outlet must be used to accommodate additional
devices.
Linked devices must be of the same make and model type. DO NOT mix devices!
F U S E R E P L A C E M E N T
Disconnect the unit from its power source. Remove the power cord from the unit, then find the fuse
holder located inside the power socket. Insert a flat-head screw driver into the power socket and gently
pry out the fuse holder. Remove the bad fuse and replace with a new one. Please note that the fuse
holder also has a holder for a spare fuse.
T R O U B L E S H O O T I N G
Listed below are a few common problems the user may encounter, with possible solutions.
Unit not responding to DMX:
Check that the DMX cables are connected and wired correctly (pin 3 is "hot"; on some other DMX
devices pin 2 may be "hot"). Also, check that all cables are connected to the right connectors, as the
way in which the inputs and outputs are connected does affect operation.
Unit does not respond to sound:
1. Quiet or high pitched sounds will not activate the unit.
2. Make sure that Sound Active mode is enabled.
C L E A N I N G
Due to fog residue, smoke, and dust, cleaning of the internal and external optical lenses must be
carried out periodically in order to optimize light output.
•
Use normal glass cleaner and a soft cloth to wipe down the outside casing.
•
Clean the external optics with glass cleaner and a soft cloth.
•
Always be sure to dry all parts completely before plugging the unit back in.
Cleaning frequency depends on the environment in which the fixture operates (i.e. smoke, fog residue,
dust, dew).
22
Advertisement
Table of Contents
