Table of Contents
Advertisement
S A F E T Y G U I D E L I N E S
This fixture is a sophisticated piece of electronic equipment. To guarantee smooth operation, it is important to
follow all instructions and guidelines in this manual. ADJ is not responsible for injury and/or damages resulting
from the misuse of this fixture due to the disregard of the information printed in this manual. Only qualified and/or
certified personnel should perform installation of this fixture and only the original rigging parts (omega brackets)
included with this fixture should be used for installation. Any modifications to the fixture and/or the included
mounting hardware will void the original manufacturer's warranty and increase the risk of damage and/or
personal injury.
PROTECTION LASS 1 – FIXTURE MUST BE PROPERLY GROUNDED.
THERE ARE NO USER SERVICEABLE PARTS INSIDE THIS UNIT. DO NOT ATTEMPT ANY
REPAIRS YOURSELF, AS DOING SO WILL VOID YOUR MANUFACTURER'S WARRANTY.
DAMAGES RESULTING FROM MODIFICATIONS TO THIS FIXTURE AND/OR THE DISREGARD
OF
SAFETY
MANUFACTURER'S WARRANTY AND ARE NOT SUBJECT TO ANY WARRANTY CLAIMS
AND/OR REPAIRS.
DO NOT PLUG FIXTURE INTO A DIMMERPACK!
NEVER OPEN THIS FIXTURE WHILE IN USE!
DISCONNECT FIXTURE FROM POWER BEFORE SERVICING!
NEVER TOUCH THE FIXTURE DURING OPERATION, AS IT MAY BE HOT!
KEEP FLAMMABLE MATERIALS AWAY FROM THE FIXTURE!
NEVER LOOK DIRECTLY INTO THE LIGHT SOURCE!
RETINA INJURY RISK – MAY INDUCE BLINDNESS!
SENSITIVE PERSONS MAY SUFFER AN EPILEPTIC SHOCK!
MAXIMUM EXTERNAL SURFACE TEMPERATURE: 185° F (85° C)
MAXIMUM AMBIENT TEMPERATURE: 104° F (40° C)
•
DO NOT TOUCH the fixture housing during operation.
•
Turn OFF the power and allow approximately 15 minutes for the fixture to cool down before serving.
•
DO NOT shake fixture, avoid brute force when installing and/or operating fixture.
•
DO NOT operate fixture if the power cord is frayed, crimped, damaged and/or if any of the power cord
connectors are damaged and do not insert into the fixture securely with ease.
•
NEVER force a power cord connector into the fixture. If the power cord or any of its connectors are damaged,
replace it immediately with a new one of similar power rating.
•
DO NOT block any air ventilation slots. All fan and air inlets must remain clean and never blocked. Allow
approx. 6" (15cm) between fixture and a wall for proper cooling.
•
When installing fixture in a suspended environment, always use mounting hardware that is at least M10 x 25
mm, and always install fixture with an appropriately rated safety cable.
•
Always disconnect fixture from main power source before performing any type of service and/or cleaning
procedure.
•
Only handle the power cord by the plug end, and never pull out the plug by tugging the wire portion of the
cord.
•
During the initial operation of this fixture, a light smoke or smell may emit from the interior of the fixture. This
is a normal process and is caused by excess paint in the interior of the casing burning off from the heat
associated with the lamp and will decrease gradually over time.
•
Consistent operational breaks will ensure fixture will function properly for many years.
•
If the fixture needs to be returned for servicing, use only the original packaging and materials to transport the
fixture.
INSTRUCTIONS
AND
GUIDELINES
IN
6
THIS
MANUAL
VOID
THE
Advertisement
Table of Contents
