ADJ PAR Z120 RGBW User Manual page 11

SYSTEM MENU
DMX 512 Address Setting
Press the either the MENU, UP, or DOWN buttons until
The current address will now be displayed and flashing. Press the UP or DOWN buttons to select your
desired address. Press ENTER to confirm and exit.
Channel Mode – Select your desired DMX channel mode.
Press the MENU button until
will be displayed.
Press the UP or DOWN buttons to find your desired DMX channel mode and
and exit.
DMX State -
signal is lost, interrupted, or power is lost, the operating mode chosen in the setup is the
running mode the fixture will go into when the DMX signal is lost. You can also set this as the
operating mode you would like the unit to return to when power is applied.
Press the MENU button until
select (Blackout) /or
ENTER and the bottom choice will begin to flash. Use the UP or DOWN buttons to choose an operating
mode you would like the unit to start up in when power is applied or the DMX signal is lost.
• BLND (Blackout) - If the DMX signal is lost or interrupted, the unit will automatically go into standby
mode.
• HOLD - If the DMX signal is lost the fixture will stay in the last DMX setting. If power is applied and
this mode is set, the unit will automatically go into the last DMX set up.
Press ENTER to confirm and exit.
is displayed and press ENTER. The current DMX channel mode
This mode can be used as a precaution mode. In the event that the DMX
is displayed and press ENTER.
(Automatic Operation Color Macro) or
is displayed, press ENTER.
Use the DOWN and UP button to
11
press ENTER to confirm
(Hold the last state). Press