Table of Contents
Advertisement
DMX SETUP
Line Termination: When longer runs of cable are used, you may need to use a terminator on the last
unit to avoid erratic behavior. A terminator is a 110120-ohm 1/4-watt resistor, which is connected
between pins 2 and 3 of a male XLR connector (DATA + and DATA -). This unit is inserted in the female
XLR connector of the last unit in your daisy chain to terminate the line. Using a cable terminator (ADJ
part number Z-DMX/T) will decrease the possibilities of erratic behavior.
9
Advertisement
Table of Contents
