Provisioning Sip Parameters - 3Com VCX V7111 Installation Manual

Provisioning SIP Parameters

To provision SIP parameters, follow these steps:
After completing the steps in sections
1
Subnet Mask" to "Restoring Your PC's IP Address / Subnet
screen shown in Figure 16 appears.
Quick Setup: Provisioning SIP Parameters
Figure 16
Under SIP Parameters, enter the VCX V7111 domain name in the Gateway Name field
2
(Figure 16). If the field is not specified, the VCX V7111 IP address is used instead
(default).
Set the Working with Proxy field to Yes or No.
3
No — The VCX V7111 does not register to the proxy (default). Typically, you select
this option when only the internal routing fields are used to route the phones, skip to
step 7.
Yes — The VCX V7111 registers to the proxy at power-up. When you select this
option enter the IP address of the Proxy IP Server in the Proxy IP Address field.
If the Proxy Name field is used, it replaces the proxy IP address in all SIP messages.
4
This means that messages are sent to the physical proxy IP address but the TO field
contains the proxy name instead.
32
"Correlating PC/VCX V7111 IP Address and
Mask", the SIP 'Quick Setup'
VCX V7111 Fast Track Installation Guide