Connecting To A Macintosh - Epson PhotoPC 800 User Manual

.
4
Turn on the camera by turning the camera dial to
then turn on your computer system.
NOTE
If you have problems connecting to the COM port you have
selected, check your computer's COM port configuration and
try again.
6-4 Getting Photos Into Your Computer

Connecting to a Macintosh

You can connect the camera to your PowerPC with the
Macintosh serial cable that came with your camera. If you
have an iMac or PowerMac G3, you can use the USB cable.
See page 6-2 for instructions on connecting the camera with
a USB cable.
Follow these steps to use the Macintosh serial cable:
1
Turn off the camera and your Macintosh.
2
Locate the modem port
the back of your Macintosh. You can use either port to
connect the camera.
,
NOTE
If you're sharing a serial port that you use for another device,
make sure AppleTalk™ is turned off. Your Macintosh may
not recognize the camera if AppleTalk is on. Also, if you have
problems connecting to the printer port, use the modem port
instead.
or printer port on