Connecting To A Macintosh - Epson PhotoPC 3000Z User Manual

5
Open the connector cover on the side of the camera.
Carefully insert the connector on the other end of the
cable into the camera's serial interface port.
NOTE
To disconnect the cable from the camera, squeeze and hold
the connector lock button on the side of the connector while
you pull the cable out.
6
Turn on the camera and turn the camera dial to
turn on your computer system.
Installing Software and Connecting
NOTE
If you have problems connecting to the COM port you have
selected, check your computer's COM port configuration and
try again. If your computer has a high-speed serial board, you may
be able to transfer your pictures at the rate of 230.4KB per
connector lock
second. If your camera software doesn't set this speed
button
automatically, you can set it manually. See your Windows help
system and your computer's documentation for instructions.

Connecting to a Macintosh

Follow these steps:
1
2
3
, then
Make sure the camera and your computer are off.
Locate the Macintosh serial cable that came with the
camera.
Locate the modem port
back of your Macintosh. You can use either port to
connect the camera.
or printer port on the
9-7