Continuous Shooting - Epson PhotoPC 800 User Manual

Continuous Shooting

In this mode, you can take two standard or fine
resolution pictures each second, with up to ten pictures in
sequence (or one super fine resolution picture per second,
with up to eight pictures in sequence). You can capture a
complex motion, such as a golf swing, in a series of steps to
create animation sequences for the Internet, screen savers, or
presentations. Continuous shooting is available for all user
modes.
NOTE
You can't use the flash for continuous shooting, so make sure
you have adequate lighting for your pictures. In addition, you can't
select the HyPict image quality setting.
1
Make sure you are at least 20 inches (50 cm) away from
your subject.
2
Open the lens cover, then turn the camera dial to
Wait until the camera status light turns green.
4-10 Using the LCD Menus to Change Settings
You see a preview of your picture on the LCD screen,
with a red frame around it. CONTINUOUS appears on
the screen.
3
Center your subject in the red frame.
4
Press and hold the shutter button all the way down. The
camera beeps as it captures each picture.
5
When the camera has captured the first sequence of
pictures, it stops beeping and the camera status light
flashes. Release the shutter button.
NOTE
If you continue to hold down the shutter button after the first
sequence of pictures, the camera will take a second sequence.
The camera will continue to take pictures until the memory card
is full.
.