Control Panels Removal/Installation - Sony DNW-A100 Maintenance Manual

Upper Lid
1. Loosen three fixing screws.
2. Remove the upper lid by moving in the direction
indicated by the arrow.
For installation, perform in the reverse procedures of
removal.
Side Panels (The right and left side panels are the same
in procedure.)
1. Remove four screws (B3
2. Remove four screws (B4
panel.
For installation, perform in the reverse procedures of removal.
Bottom Plate
n
. With the handle attached, place the unit on its right side
panel down for removal and installation. Lend your hand
so that the lower handle does not hang down.
. Be careful not to shock the hard disk drive when laying
the unit.
1. Remove six screws (B4
plate.
For installation, perform in the reverse procedures of removal.

2-3-2. Control Panels Removal/Installation

n
Turn off the power and unplug the power cord before
starting the removal/installation.
Upper Control Panel
1. Removal the upper lid.
(Refer to "2-3-1. Upper Lid, Side Panels, and Bottom
Plate Removal/Installation".)
2. Remove the each one screw on the left and right side.
3. Take both side handles on a lower control panel and pull
them slightly forward, then pull them more strongly.
Then the lower control panel tilts upward (to 90 degrees
position).
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
http://getMANUAL.com
x 6), and remove the handle.
6), and remove the side
x
x 6), and remove the bottom
4. Unhook two hooks at lower portion on the upper
control panel.
BVTT3 x 6
Lower control panel
5. Unhook the lugs at the upper control panel from the
chassis, and remove in the direction of the arrow.
Upper control panel
For installation, perform in the reverse procedures of
removal.
n
Insert the hooks at the back of the panel into the convex
portions of the chassis, then install the panel in the chassis.
(Refer to the figure below.)
BVTT3 x 6
Hook
Upper control panel
Hook
2-3. Removal/Installation of Cabinet
Hook
BVTT3 x 6
BVTT3 x 6
2-3